How to use the 32SB180J spray pump?

How to Use the 32SB180J Spray Pump?The 32SB180J spray pump is an essential coating spraying equipment, and proper usage and maintenance can prolong its service life and improve work efficiency. Below are the steps for using this spray pump and its routine lubrication maintenance.

(1) Preparation Stage: 
A. Rotate the pump shaft manually to ensure smooth operation without any friction noise. 
B. Fill the pump body and inlet pipe with water to expel any trapped air. 
C. Note that the pump should not be operated without liquid for more than 5 seconds; it must be filled with liquid before starting to avoid damaging the mechanical seal.

(2) Startup and Operation: 
A. After the preparation is completed, start the prime mover and gradually open the throttle valve to the required flow rate. 
B. During operation, if any abnormal noise or other irregularities are noticed, stop the pump immediately for inspection and troubleshooting.

(3) Routine Lubrication and Maintenance:
A. Bearing Lubrication: The bearings are lubricated with general lithium-based grease and should be replaced every 1500 hours of operation.
B. Winter Shutdown Precautions: When the pump is not in use during the winter, ensure that all water inside the pump is drained to prevent freezing and damage to the pump casing.

By following the correct usage and performing regular lubrication and maintenance, the 32SB180J spray pump will run smoothly, operate efficiently, and enjoy an extended service life. If any abnormalities are detected during usage or maintenance, seek professional technical support promptly.